Configuring A Hard-Disk Drive For Logging - Nokia IP560 - Hard Disk Drive Based Installation Manual

3. Slide the chassis tray assembly back into the appliance until it clicks into place.
4. Resecure the two chassis tray assembly retaining screws.

Configuring a Hard-Disk Drive for Logging

On the flash-based IP560, you can save log files locally by installing and configuring an optional
hard-disk drive. The Nokia Network Voyager Reference Guide and the CLI Reference Guide for
Nokia IPSO contain instructions for configuring a Nokia appliance to store Nokia IPSO log
messages on the disk. This section explains how to configure an optional disk and configure it to
store Check Point log messages on an IP560.
If you perform all the procedures explained in this document, you must reboot your appliance
several times.
To install and configure an optional disk in an IP560
1. If necessary, install the optional disk in the appliance as described in
Replacing a Hard-Disk Drive"
2. Restart the appliance if appropriate.
3. Start Nokia Network Voyager.
4. Navigate to the Optional Disk configuration page.
Network Voyager displays information about the device you installed.
5. Select the device in the Choose column.
6. Click Apply.
7. Wait until you see a message indicating that you should reboot the appliance.
There is a short delay (possibly a few minutes) before the message appears. The delay is
longer with devices of larger capacity.
8. When the message appears, click Reboot, Shutdown System.
9. Reboot the appliance.
10. When the appliance has rebooted, log into it and start Nokia Network Voyager.
IP560 Security Platform Installation Guide
SL OT
1
SL OT
2
SL OT
3
1
2 SL OT
4 3
4
on page 88.
Configuring a Hard-Disk Drive for Logging
"Installing or
00359
93