Installing And Replacing Adp Modules; Before You Begin - Nokia IP560 - Hard Disk Drive Based Installation Manual

6
Installing, Using, and Replacing ADP Services Modules

Installing and Replacing ADP Modules

Note
Before you begin this procedure, you should review all ADP module information in the Nokia
Getting Started Guide and Release Notes for the version of Nokia IPSO you are using and
refer to both of these documents as needed as you complete the installation and
configuration process.
Use these instructions to install an ADP module in your appliance.

Before You Begin

To install a Nokia ADP module, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Nokia Network Voyager or the CLI
A suitable, grounded work surface
The ADP module kit
Note
You do not need to manually disconnect power for this procedure. Any servicing of the
appliance, however, should be completed with the chassis tray assembly fully removed from
the appliance.
To install an ADP module in IP560 appliances
1. You cannot preserve the configuration for slot 2 of your appliance when you replace your
PMC NICs with an ADP module or, conversely, when you replace your ADP module with
PMC NICs due to interface naming convention differences. Therefore, you need to delete all
existing configurations associated with slot 2.
Note
You do not need to delete the slot 1 configuration for the first 4 ports, as the naming
conventions for the first 4 ports for Slot 1 remain the same when you use an ADP
module rather than a NIC. Naming conventions for slots and ports are provided in
ADP Module Interface Names for IP560 Appliances"
2. Upgrade the Nokia IPSO software to the required version as described in the Nokia Getting
Started Guide and Release Notes that you received with your appliance.
3. Use Network Voyager or the command-line interface (CLI) to perform an orderly shutdown
of the IP560 appliance.
64
on page 74.
IP560 Security Platform Installation Guide
"Nokia