Table of Contents
Advertisement
7
Installing and Replacing Components Other than Network Interface Cards (NICs) and Accelerated Data Path
Caution
To prevent the card from ejecting too quickly, hold the PC card while you push the eject
button.
4. Reboot the appliance.
Installing or Replacing a Hard-Disk Drive
The disk-based IP560 comes with one hard-disk drive, and supports a second optional drive and
disk-mirroring starting with Nokia IPSO 4.1, Build 016. For information about disk mirroring,
see the document Important Information: Regarding Disk Mirroring, which is available on the
Nokia support site.
The flash-based IP560 also supports one optional hard-disk drive that you can use for logging.
Note
Starting with Nokia IPSO 4.1, one or two hard drives are supported. However, you can use
only one disk for logging in flash-based IP560 appliances.
When you purchase your IP560, you can order optional hard-disk drives for factory installation,
or you can order them later and install them yourself, as described in this chapter.
Disk-based appliances use the disk for Nokia IPSO and the Check Point application; the
compact flash memory contains only the boot manager.
You can use a hard-disk drive for storing log files. See
Logging"
flash-based IP560 appliances. For the disk-based IP560, you do not need to configure the hard-
disk drive for logging.
This section describes how to install or replace a hard-disk drive.
Before You Begin
Caution
Hard-disk drives are susceptible to damage from shock. Handle them with care.
Caution
To help guard against electrostatic discharge damage, make sure you are properly
grounded by using a grounding wrist strap and following the instructions provided with
the wrist strap before you handle the components or open the appliance or gateway. If
88
on page 93 for information about configure the hard-disk drive for logging on
"Configuring a Hard-Disk Drive for
IP560 Security Platform Installation Guide
Advertisement
Table of Contents
Troubleshooting
