Fiber-Optic Gigabit Ethernet Nic Connectors And Cables; Figure 20 Pmc Two-Port Short-Range Gigabit Ethernet Nic; Figure 21 Pmc Two-Port Long-Range Gigabit Ethernet Nic - Nokia IP560 - Hard Disk Drive Based Installation Manual

Figure 20
Gigabit Ethernet NIC you can use in IP560 appliance.

Figure 20 PMC Two-Port Short-Range Gigabit Ethernet NIC

Figure 21
Gigabit Ethernet NIC you can use in your IP560.

Figure 21 PMC Two-Port Long-Range Gigabit Ethernet NIC

After the power is turned on and the cables are connected, the Ethernet link LEDs on both the
IP560 and on the remote equipment illuminate to indicate the connection. As data is transmitted,
the activity LEDs on the appliance illuminate.

Fiber-Optic Gigabit Ethernet NIC Connectors and Cables

For short-range NICs, to connect the fiber-optic Gigabit Ethernet NIC to other network
components, use a multi-mode, fiber-optic cable with an LC connector for each NIC interface.
You can use either 50 or 62.5 micron cable; 50 micron-type cable provides longer transmission
reach.
For long-range NICs, to connect the fiber-optic Gigabit Ethernet NIC to other network
components, use a single-mode, fiber-optic cable with an LC connector for each NIC interface.
The destination end of the cable can be either LC or SC, depending on the type of connector
required for the destination Gigabit Ethernet device. You can also use a half-duplex LC-to-LC
cable to loop back the transmit port of an interface to the receiver port. LC and SC define the
fiber-optic connector types; LC connectors are smaller than SC connectors.
IP560 Security Platform Installation Guide
shows the front panel details for the two-port short-range (1000 BASE-SX) fiber-optic
Ports
shows the front panel details for the two-port long-range (1000 BASE-LX) fiber-optic
Ports
Two-Port Fiber-Optic Gigabit Ethernet NICs
Link LEDs (solid green)
Activity LEDs (blinking amber)
00206
Link LEDs (solid green)
Activity LEDs (blinking amber)
LINK
ACT
00555
61