6. Loosen the four retaining screws and remove the card.
Caution
Do not use the PMC connectors located at the front of the motherboard for the
acceleration card. Those connectors are for NICs and ADP modules.
7. Position the three male PMC connectors on the card over the three female PMC connectors
on the motherboard.
The two sets of connectors should be aligned with each other. The four screw holes and four
standoffs should also be aligned with each other.
8. Push down on the card until it is properly seated on the motherboard.
IP560 Security Platform Installation Guide
Replacing a Nokia Encryption Accelerator Card
00517
00518
101