Nokia IP560 - Hard Disk Drive Based Installation Manual page 23

Note
To use the cable for modem connections from the auxiliary port, you need to order a modem
cable kit. For information about contacting Nokia to order the kit, see
Information"
Note
The cable described in this section is a rollover cable, which is required for IP560 console
and auxiliary port connections. You cannot use standard Ethernet cables for IP560 console
and auxiliary connections.
To connect the cable, push the connector into the receptacle, as you would with other similar
cables. To disconnect the cable, push the cable toward the appliance, pull back on the boot to
release the latch, and pull the connector out of the receptacle.
You can connect the other end of the cable to a DB-9 console connection (using the appliance
console port and the DB-9 female adaptor) or to a DB-25 modem connection (using the
IP560 Security Platform Installation Guide
on page 3.
To connect the cable
To disconnect the cable
Nokia IP560 Security Platform Overview
1 + 2 =
Pull boot
2
Push cable
1
"Nokia Contact
00548a
23