Ethernet Nic Connectors And Cables; Figure 13 Output Connector For The Ethernet Cable - Nokia IP560 - Hard Disk Drive Based Installation Manual

Ethernet NIC Connectors and Cables

The Ethernet connectors on the four-port 10/100 Ethernet NICs are RJ-45 connectors. Use a
straight-through cable to connect the NIC to a 10-Mbps or 100-Mbps hub or switch, or a
crossover cable to connect directly to a host.
Use ANSI TIA/EIA-568-A/B compliant (Cat 5 or Cat 5e) unshielded twisted pair cable. You can
order appropriate adapter cables separately from a cable vendor of your choice.
Caution
Cables that connect to the Ethernet card must be ANSI TIA/EIA-568-A/B compliant
(Cat 5 or Cat 5e) to prevent potential data loss.
Figure 13
to left, with the copper tabs facing up and toward you.

Figure 13 Output Connector for the Ethernet Cable

IP560 Security Platform Installation Guide
shows the pin assignments for the RJ-45 cable. The connector is numbered from right
8 1
Pin Assignment
1 TX +
2 TX -
00270
3 RX +
4
5
6 RX -
7
8
Four-Port 10/100 Ethernet NIC
55