Four-Port 10/100 Ethernet Nic; 10/100 Ethernet Nic Features; Figure 12 Four-Port 10/100 Ethernet Nic Front Panel Details - Nokia IP560 - Hard Disk Drive Based Installation Manual

5
About IP560 Appliance Network Interface Cards

Four-Port 10/100 Ethernet NIC

The IP560 supports Nokia-approved, four-port UTP5 dual-mode (10-Mbps and 100-Mbps)
Ethernet NICs installed in a PMC expansion slot. When you purchase a 10/100 Ethernet NIC
with your IP560, the NIC is installed before the appliance is delivered to you. For information
about how to add or replace a NIC, see
Cards."

10/100 Ethernet NIC Features

The four-port 10/100 Ethernet NIC supports PCI operation at 133 MHz and runs on Nokia IPSO
v4.0.1 or higher.
In the IP560, the four-port Ethernet NIC supports the following features:
Tracing through tcpdump
High bandwidth
Full-duplex mode operation up to 100 Mbps
Link speed auto advertising (10/100)
PCI operation at 133 MHz
Compliance with IEEE 802.3ab Gigabit Ethernet specifications
You can configure and monitor Ethernet NIC interfaces by using Nokia Network Voyager.
Specifically, you set the port speed and full-duplex or half-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related reference materials, see
"Using Nokia Network Voyager"

Figure 12 Four-Port 10/100 Ethernet NIC Front Panel Details

After the power is turned on and the cables are connected, the Ethernet link LEDs on both the
IP560 and on the remote equipment illuminate to indicate the connection. As data is transmitted,
the activity LEDs on the appliance illuminate.
54
Chapter 4, "Installing and Replacing Network Interface
on page 42.
1 2
1
2
3
4
Link LEDs (solid green)
Activity LEDs (blinking green)
Ports
3 4
00641
IP560 Security Platform Installation Guide