Configuring Software To Use Hardware Acceleration - Nokia IP560 - Hard Disk Drive Based Installation Manual

7
Installing and Replacing Components Other than Network Interface Cards (NICs) and Accelerated Data Path
9. Place the screws through the standoff holes on the card and into the standoffs on the
motherboard.
10. Turn each screw clockwise to attach the card to the standoffs. Do not overtighten.
Make sure that all four standoff connections are properly aligned before tightening the
screws completely.
11. Slide the chassis tray assembly back into the appliance until it clicks into place resecure the
two retaining screws.
12. Configure your software to use hardware acceleration by following the instructions in

"Configuring Software to Use Hardware Acceleration"

Configuring Software to Use Hardware Acceleration
The Nokia encryption accelerator software package is part of the Nokia IPSO operating system,
so the appliance automatically detects and configures the Nokia encryption accelerator card.
For the Nokia IP560 appliances, SecureXL is on by default. After you install the Nokia
encryption accelerator card and reboot the appliance, SecureXL automatically uses the Nokia
encryption accelerator card for encryption acceleration. If you do not want to use SecureXL for
encryption acceleration, use the Check Point cpconfig utility to disable SecureXL.
You can also configure the IP560 appliances to use the Nokia encryption accelerator card for
IKE acceleration. When you enable IKE acceleration, the Nokia encryption accelerator card
performs cryptographic operations for IPsec tunnel negotiation.
102
00175.1
SL OT
1
SL OT
2
SL OT
3
1
2
3 SL OT
4
4
Screw
Accelerator card
Standoff hole
Motherboard standoff
on page 102.
IP560 Security Platform Installation Guide
00359