Copper Gigabit Ethernet Nic Connectors And Cables; Figure 18 Gigabit Ethernet Cable Connector Output Pin Assignments - Nokia IP560 - Hard Disk Drive Based Installation Manual

Copper Gigabit Ethernet NIC Connectors and Cables

The copper Gigabit Ethernet NIC receptacles are for RJ-45 connectors.
Caution
Cables that connect to the Gigabit Ethernet card must be ANSI TIA/EIA-568-A/B
compliant (Cat 5 or Cat 5e) to prevent potential data loss.
To connect to a 1-Gbps hub, switch, or router, use a straight-through RJ-45 cable (Cat 5 or Cat
5e type cable, or as required by your network configuration).
In Figure
pins facing up and toward you.

Figure 18 Gigabit Ethernet Cable Connector Output Pin Assignments

To connect directly to a host, use an RJ-45 crossover cable wired as
IP560 Security Platform Installation Guide
Four-Port and Two-Port Copper Gigabit Ethernet NIC (10/100/1000)
18, the RJ-45 cable output connector is numbered from right to left, with the copper
8 1
1000 Mbps
Pin# Assignment
1 BI_DA+
00270
2 BI_DA-
3 BI_DB+
BI_DC+
4
BI_DC-
5
6 BI_DB-
7 BI_DD+
8 BI_DD-
10/100 Mbps
Assignment
TX+
TX-
RX+
RX-
Figure 19 shows.
59