Nokia IP560 - Hard Disk Drive Based Installation Manual page 69

Take care that the EMI
gaskets don't roll back
during ADP module
installations
Arrows indicate locations
where gaskets might roll
back
b. Gently push the back of the ADP module down toward the motherboard being sure to
12. If the ADP module memory card is installed, you should remove it to provide access the
retaining screw hole at the right side of the module.
13. From the top of the chassis tray assembly, screw the two retaining screws into the standoffs
on the back of the module.
Note
Extra screws are included in your ADP module kit in case you don't have appropriate
screws on hand.
IP560 Security Platform Installation Guide
the back of the module down, you should detect little or no resistance; if you do, check to
ensure that the EMI gaskets have not rolled back.
S L O
T 1
push down only where the module connectors are located. Be sure that the module is
completely seated into both connectors on the motherboard.
Installing and Replacing ADP Modules
Push down only at these two points and ensure
that both connectors are completely seated
S L O
T 2
1
2
3
4
1
2
3
4
00650
Memory card location
00443a
69