Nokia Adp Module Led Reference Information - Nokia IP560 - Hard Disk Drive Based Installation Manual

6
Installing, Using, and Replacing ADP Services Modules
Note
Depending on the design of your transceiver, you might need to rotate the latch lever
upward to release the device.
To remove an ADP transceiver:
Note that if you install any ADP transceivers that are not supported by Nokia, they are not
recognized by Nokia IPSO; the system rejects the transceivers and includes them in a list of
rejected interfaces on the Interface Configuration page in Nokia Network Voyager, as shown in
the following figure.
Note
The Non-Supported SFP Components table appears only if you have ADP transceivers
installed that are not supported by Nokia.

Nokia ADP Module LED Reference Information

All Nokia IP560 ADP modules provide a single LED for each port. The LED illuminates solid
green for Link status and blinks green to indicate Activity.
72
Push the transceiver into an available port in the ADP module.
Rotate the transceiver latch lever down to secure the transceiver in the ADP module.
Insert an appropriate interface cable into the transceiver.
Remove the cable.
Release the transceiver by rotating the latch lever.
Pull out the transceiver.
IP560 Security Platform Installation Guide