Installing Nics; Before You Begin - Nokia IP560 - Hard Disk Drive Based Installation Manual

4
Installing and Replacing Network Interface Cards
Deactivate all of the physical interfaces on the NIC.
If you do not deactivate the interfaces before removing the NIC, you may have to reinstall the
NIC to deactivate its logical and physical interfaces in Network Voyager.
For information about how to access Network Voyager, see
page 42.

Installing NICs

Note
Before removing a configured network interface card with these instructions, you must
deactivate the NIC by using Nokia Network Voyager. For additional information, see
"Deactivating Configured Interfaces"
Use these instructions to install a NIC in the IP560. Some steps are not applicable to all
procedures. The instructions point out steps appropriate to each procedure.

Before You Begin

To install a Nokia NIC, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Nokia Network Voyager or the CLI
A suitable, grounded work surface
A field replaceable unit kit, including the NIC
Note
You do not need to manually disconnect power for this procedure. Any servicing of the
appliance, however, should be completed with the chassis tray assembly fully removed from
the appliance.
To install a network interface card
1. Use Nokia Network Voyager or command-line interface (CLI) to perform an orderly
shutdown of the IP560 appliance.
For information about how to access Network Voyager and the related reference materials,
see
2. Turn off the power to the IP560 appliance.
48
"Using Nokia Network Voyager"
"Using Nokia Network Voyager"
on page 47.
on page 42.
IP560 Security Platform Installation Guide
on