Nokia IP560 - Hard Disk Drive Based Installation Manual page 41

Security platform
Hide thumbs Also See for IP560 - Hard Disk Drive Based:
Table of Contents

Advertisement

The prompt remains on the screen for about five seconds. If you type any character during
this time, the appliance activates the Nokia IPSO boot manager.
BOOTMGR[0]>
Note
For information about using the boot manager, see the Nokia IPSO Boot Manager
Reference Guide.
After some miscellaneous output, the following prompt appears:
Hostname?
If the Hostname? prompt does not appear on the console, check the console port and console
display connections to ensure that the serial cable is completely plugged in at both ends. If
you verify the console connections and still do not see either the BOOTMGR> or
Hostname? prompts, verify that the terminal or terminal emulator program settings are
correct. If the settings are correct, contact your Nokia service provider as listed in
Contact Information"
3. Respond to the Hostname? prompt within 30 seconds to prevent the DHCP client from
starting.
If the DHCP client starts, it might configure the appliance with an incorrect host name and
IP address (this could happen if a DHCP server on your network is configured to respond to
any request). To reset the incorrect host name and IP address:
a. Establish a console connection to the appliance.
b. Log into the system using the user name admin and the password password.
c. Enter the following:
d. Reboot the appliance.
e. Respond to the Hostname? prompt within 30 seconds to prevent the DHCP client from
4. At each subsequent prompt, enter the requested configuration information.
For more information about how to respond to the prompts during the initial configuration
process, see the release notes for the Nokia software release you are running.
5. To select an interface, enter the number adjacent to the physical ID in the list of connected
interfaces.
Note
A physical ID identifies the interface type (nic_type) and provides information about its
slot number (slot_num) and port number (port_num). The physical ID syntax is:
IP560 Security Platform Installation Guide
on page 3.
rm /config/active
or
mv /config/active
/config/active.old
restarting.
Performing the Initial Configuration
"Nokia
41

Advertisement

Table of Contents
loading

Table of Contents