Reconfiguring Vrrp - Nokia IP560 - Hard Disk Drive Based Installation Manual

6
Installing, Using, and Replacing ADP Services Modules
The following figure shows the example system after the configuration information for all of
the removed interfaces has been deleted:
9. If appropriate, configure the ADP interfaces to use the IP addresses previously assigned to
the removed interfaces.
In this example, you need to assign the address 10.1.1.1 to the new interface eth-s1p5c0.

Reconfiguring VRRP

After you finish reconfiguring interfaces, you need to reconfigure any protocols and features that
used the removed interfaces to use the ADP interfaces.
80 IP560 Security Platform Installation Guide