Messages; When The Messages Below Are Displayed - Kyocera Ai2310 Instruction Handbook Manual

MESSAGES

When the messages below are displayed

When any of the messages below appear on the message display, take the indicated action.
Message
"Close xxx cover."
"Add paper in drawer."
"Set drawer."
"Drawer inoperable. Call for service."
"Check paper size."
"Reposition original or change drawer."
"Exceeded pre registered copying
quantity."
"Reset all originals in feeder."
"Reset all originals in feeder."
133
The displayed cover is open. Close it/them securely.
There is no paper in the displayed drawer. Load paper of the indicated size.
One of the drawers is not closed properly. Pull it out, and push it back in all the
way.
The drawer currently in use is out of order and cannot be used for the moment.
Contact your service representative as soon as possible. Continue copying using
another drawer.
No paper that can be used in the selected mode is loaded. Check the paper.
The orientation of the original and the selected paper are different. Change the
orientation of the original. If the Start key is pressed, same-size copying will be
performed.
Since the number of copies set in the copy management mode reached the set
limit, copying can not be performed any more. Clear the copy count from the
management mode.
An original(s) has not been fed correctly from the DF. Remove all originals and
reset from the first page.
An original has been misfed inside the DF. Remove the misfed original following
the procedure, remaining the main switch ON ( | ).
Action Page
-----
29
-----
-----
-----
-----
104
-----
-----