Kyocera Ai2310 Instruction Handbook Manual page 139

3010/2310 instruction handbook
Hide thumbs Also See for Ai2310:
Table of Contents

Advertisement

Message
"Ready to copy.
Add toner to resume copying."
"Add toner to resume copying"
"Call for service."
"Time for maintenance"
"Memory is full."
"Paper misfeed."
"Install Finisher."
"Check paper in Finisher.
Incomplete copies inside."
"Finisher is out of order.
Detach Finisher."
"Paper capacity exceeded. Remove
paper from Finisher."
"Remove paper from inner tray of
Finisher."
"Out of staples. Add staples."
"Cannot staple this size."
There is not enough toner in the copier. Replace the toner cartridge immediately
as only one copy at a time can be made.
There is not enough toner in the copier to make copies. Replace the toner
cartridge immediately.
Open and close the front cover. If this message does not disappear, make a note
of the "C" and number appearing with it, turn the main switch OFF (O), and
contact your service representative.
Periodic maintenance is necessary to keep your copier in good condition. Contact
your service representative as soon as possible.
The copier's memory is full. Either print out or clear all scanned data. It is not
possible to copy or scan another original until one of these two operations is
performed.
If paper is misfed, the copier will stop, and the location of the misfeed will be
displayed on the message display. Remove the misfed paper with the main switch
ON ( I ) in accordance with the procedure.
The finisher (optional) is not installed correctly. Install it securely.
Unfinished copies were ejected onto the finisher (optional) due to a problem in
copying. Check and remove those copies.
The copier is inoperable due to a problem in the finisher (optional). Contact your
service representative.
The number of sheets in the finisher (optional) exceeds the capacity. Remove
them.
Paper has been misfed inside the finisher (optional). See the finisher's instruction
handbook to remove paper.
There are no staples in the finisher (optional). See the finisher's instruction
handbook to load staples.
Stapling cannot be done with small size paper, such as 8
finisher's instruction handbook.
Action
" x 5
". See the
1/2
1/2
Page
139
139
-----
-----
-----
141
-----
-----
-----
-----
-----
-----
-----
134

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ai301030102310

Table of Contents