Names Of Parts; Main Body; Nomenclature - Kyocera Ai2310 Instruction Handbook Manual

NAMES OF PARTS

NOMENCLATURE

(1) Main body

1 Original cover <optional>
(Open/close to set the original on the platen. It has a pocket for
holding originals on the top.)
2 Operation panel
(Contains the keys and controls for operating the copier.)
3 Ejection unit (or branch unit 3)
(Pull out when a paper misfeed occurs in the ejection section.
The copier is equipped with a branch unit when the optional duplex
unit or finisher is installed.)
4 Paper transfer section cover
5 Paper transfer section cover release lever
(Operate when a paper misfeed occurs in the paper transfer
section.)
6 Left 1 cover
(Open when a paper misfeed occurs in the paper feed section.)
7 Left 2 cover
(Open when a paper misfeed occurs in the paper feed section.)
8 Toner cartridge
9 Toner cartridge release lever
(Operate to replace the toner cartridge.)
0 Paper feed section knob
(Operate to remove paper misfed in the paper feed section.)
! Front cover
(Open to replace the toner cartridge or to remove misfed paper.)
19
3
4
5
‹
6
7
‹
@ Drawer 1
(Holds up to 550 sheets of standard paper [standard paper specified
by our company].)
# Drawer 2
(Holds up to 550 sheets of standard paper [standard paper specified
by our company].)
$ Platen
(Set originals here for copying. Lay originals face-down with the
edges aligned with the size scales on the left and rear sides of the
platen.)
% Original size scales
(Be sure to align the original with these when setting the original on
the platen.)
^ Ejection section
& Length adjustment plate
(Adjust with the length of the paper to be set in the drawer.)
* Width adjustment lever
(Hold the lever and adjust the width guide with the width of the
paper to be set in the drawer.)
( Main switch
(Turn ON ( | ) before trying to copy.)
) Copy store section
(Copied paper is stored here.)
⁄ Multi-Bypass <optional>
(Load paper here when copying onto small-size paper or
transparencies. 11" x 8 " size or smaller paper can be copied
1/2
without opening the multi-bypass.)
¤ Insert guides
(Be sure to set the paper width when loading paper on the multi-
bypass.)
‹ Handles for transport
(Pull out, then it becomes handle. The copier has four handles.)
1
2
8
9
0
!
@
#