FUTABA 3PJ Super Instruction Manual page 59

3. Set the trigger position with
the + or - key.
When the throttle trigger is
slowly pulled to the forward
side after setting, a * will be
displayed on the screen at the
set position.
4. (Preset position setting)
Press the SELECT key once.
The display switches to the
preset position set-up screen.
5. Adjust the preset position
with the + or - key.
Setting Example: (When amp used with an electric car)
Set the preset position to F75% at ATV100%.
6. (Trigger operation wait)
Press the SELECT key once.
The display switches to the
throttle trigger operation wait
set-up screen.
7. Press the + and - keys simul-
taneously for about one sec-
ond. The screen shown at the
right will appear and the trig-
ger operation wait state is set.
The ''RDY' characters flash.
If the throttle trigger is moved to the set position while 'RDY' is flashing, the throttle
servo will move to the set position. The throttle operation wait state is reset when the
throttle trigger is returned.
-When using the Start function, always set the function by performing
steps 6 and 7 above each time.
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
- Return to the initial value (OFF)
by pressing the + and - keys si-
multaneously for about one sec-
ond.
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
Blink
Setting range: OFF, 5~100%
Blink
Blink
Setting range: B100~0~F100%
"B": Brake side, "F": Forward side
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.
Blink
Blink
Blink
59