Steering Atv - FUTABA 3PJ Super Instruction Manual

The ATV function is used to set the steering servo travel
in both directions using the linkage. Make this setting
when the left and right turning angles and the turning ra-
dius differ with the characteristics of the model.
Warning
When steering, be sure that the servo does not strike
the knuckle stopper and unreasonable force is not
applied to the servo horn.
Excessive force applied to the servo horn may result in damage to the
servo and loss of control.
Before setting the steering ATV, set for 100%
maximum servo travel using the steering D/R
dial (initial setting: GD1).
1. Access the DIRECT mode by
pressing the DIRECT key.
2. Call the ATV function set-up
screen by pressing the ATV
key.
3. To set the steering right side,
turn the steering wheel fully
clockwise and increase and
decrease the servo
throw with the + and -
keys.
4. To set the steering left side,
turn the steering wheel fully
clockwise and increase and
decrease the servo
throw with the + and -
keys.

Steering ATV

DIRECT ST.EXP
UP
SETUP
SELECT DOWN
TH.EXP ATV
DIRECT ST.EXP
UP
SETUP
SELECT DOWN
TH.EXP ATV
DIRECT ST.EXP
UP
SETUP
SELECT DOWN
TH.EXP ATV
- Return to the initial value (100%) by pressing the + and - keys
simultaneously for about one second.
DIRECT ST.EXP
UP
SETUP
SELECT DOWN
TH.EXP ATV
- Return to the initial value (100%) by pressing the + and - keys
simultaneously for about one second.
- Select the ATV setting at the
contact point.
100%
M.SEL
+
RESET
-
CUSTOM
M.SEL
+
RESET
-
CUSTOM
Blink
M.SEL
+
RESET
-
CUSTOM
Blink
Setting range; 30~120%
M.SEL
+
RESET
-
CUSTOM
Blink
Setting range: 30~120%
33