FUTABA 3PJ Super Instruction Manual page 18

Transmitter T3PJ SUPER (Rear)
(See page 20 for the
handling instructions.)
RF module
Battery cover
- When changing the Ni-cad battery pack, or dry
cell batteries, remove this cover.
Ni-cad Battery
Replacement
(For Ni-cad battery system)
The Ni-cad battery is connected by a
connector so that it can be removed
when you will not be using the trans-
mitter for a long time, or when replac-
ing a dead battery with a spare bat-
tery.
- Always use an NT8F700B Ni-cad battery.
Ni-cad battery
18
(See page 20 for the
handling instructions.)
DP-16K
Data Pac
NT8F700B
Charging jack
DSC jack
(See page 103 for the handling instructions.)
(The DSC cord sold separately is necessary.)
CHG
DSC
Dry cell Battery
Replacement
(For dry cell battery system)
1. Slide the transmitter battery
cover in the arrow direction
while pressing the part shown
in the figure.
2. Load the eight batteries in ac-
cordance with the polarity
markings on the battery holder.
3. Slide the battery cover back
onto the transmitter.
While pressing
this part.
Battery cover
Dry cell battery (x8)