FUTABA 3PJ Super Instruction Manual page 30

2. Modulation Mode Check
The T3PJ SUPER transmitter output signal format can
be changed to match the type of receiver. Check if the
modulation mode is set to match the receiver used.
When using an FM receiver (e.g., R113F), the modula-
(PPM)
tion mode must be set to PPM. When using a PCM re-
ceiver (e.g., R113iP), the modulation mode must be set
to PCM. If this setting is incorrect, change it with the
Mode Select (page 93) function.
(PCM)
3. Trims Initial Set-Up
- Steering trim (Trim 1) check
At initial set-up, steering trim (Trim 1) is assigned to
digital trim DT1 above the steering wheel. Operate the
DT1 lever and check if the steering trim display on the
screen changes. After checking the trim, set the trim
display to the center (N) position.
- Throttle trim (Trim 2) check
At initial set-up, throttle trim (Trim 2) is assigned to
digital trim DT2 at the left side of the steering wheel.
Operate the DT2 lever and check if the throttle trim dis-
play on the screen changes. After checking the trim, set
the trim display to the center (N) position.
- Steering dual rate (D/R) check
At initial set-up, steering dual rate (D/R) is assigned to
grip dial GD1 (upper) at the grip of the transmitter. Op-
erate the GD1 dial and check if the D/R value displayed
on the screen changes. After checking D/R, set the
steering dual rate to 100%.
- Throttle ATL (ATL) check
At initial setting, throttle ATL (ATL) is assigned to
grip dial GD2 (lower) at the grip of the transmitter. Op-
erate the GD2 dial and check if the ATL value dis-
played on the screen changes. After checking ATL, set
throttle ATL to 100%.
30