FUTABA 3PJ Super Instruction Manual page 31

(Set-Up Procedure When Installed In a Car)
When installing the servos in a car, performing function set-up in the following order
is recommended.
1. Perform step 3. Trims Initial Set-Up of Preparations on the
preceding page.
2. Set the servo direction of operation using the Reverse
function. (Page 87)
The servo installation method and linkage direction depends
on the kit. Therefore, the servo operation direction may have
to be reversed relative to transmitter operation. Before in-
stalling the servo, check the operating direction and set it us-
ing the Reverse function.
3. Set the subtrim and adjust the servo neutral point. (Page
47)
4. Set the trigger travel by adjusting the throttle trigger me-
chanical ATL to you liking. (Page 17)
5. Set ATV of each channel and adjust the servo throw
(travel). (Pages 33~ 38)
31