FUTABA 3PJ Super Instruction Manual page 21

3PJ SUPER and 3VC transmitter data pack compabilitily
- Note that the digital trim 3 (DT3) and slide switch (SLD) initialization values are
different.
- The 3VC transmitter does not have a digital trim function reverse function. There-
fore, when the 3PJ SUPER transmitter copied data to a 3VC transmitter, the 3VC
ignores the copied data. However, since the data is stored as is, when the data is re-
copied to the 3PJ SUPER transmitter, the 3PJ SUPER will operate using the original
settings.
Set data backup
The set data of each function (transmitter body and data pack) of the 3PJ SUPER
transmitter is stored in a memory element that does not require a backup battery.
Therefore, the 3PJ SUPER transmitter can be used without paying attention to the
backup battery life.
Adaptation For Left-Hand Use
This transmitter can be modified for left-hand use.
1. Remove the Transmitter Battery. Carefully re-
move the 5 screws from the rear case cover.
Do not use excessive force to get the case
apart.
2. Carefully remove the 2 gold screws and 1
black screw at the top of the handle. Be very
careful the Display switch cover will fall out.
3. Rotate the handle and reinstall the screws in
same position as they were removed. Make
sure you do not pinch or put excessive pres-
sure no any wires. Do not overtighten the
screws.
4. Place the Display switch cover in position and
reinstall the rear case cover. Again be careful
and do not overtighten the screws.
PILOT
DIRECT M.SEL
ST.EXP
UP +
SETUP RESET
DOWN -
TH.EXP ATV CUSTOM
CHG
DSC
21