FUTABA 3PJ Super Instruction Manual page 36

5. To adjust the brake side
(back side), push the throttle
trigger all the way to the
brake side and adjust the per-
centage with the + and - keys.
However, when using an FET
amp, set the percent-
age to 100%.
6. At the end of adjustment,
press the DIRECT key twice.
(Returns to the initial screen.)
ATL Trim
During operation, the brake side servo can be adjusted with the ATL trim. When
adjusting the servo with throttle ATV, ATL must be set for maximum travel in ad-
vance.
Maximum travel
The throttle ATV function determines the maximum servo travel. However, when the
following functions are adjusted, the maximum travel may exceed the limit set by the
ATV. Be sure to inspect your linkage installation after any adjustment is made.
- Throttle subtrim
- Programming (When throttle is set to slave side)
- Idle-up
- Throttle preset
Note
When the travel is insufficient even when ATV is increased up to 120%, it can be
increased somewhat by using programmable mixing.
(See page 84.)
To adjust the brake side (back side), push the throttle trigger all the way to the
brake side and adjust the percentage with the + and - keys. However,
when using an FET amp, set the percentage to 100%.
36
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
- Return to the initial value (100%) by pressing the + and - keys
simultaneously for about one second.
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
- 2 times
Blink
Setting range; 0~120%