FUTABA 3PJ Super Instruction Manual page 54

15. At the end of adjustment.
press the DOWN key three
times, or press the DIRECT
key twice. (The display re-
turns to the initial screen.)
Switch Setting
The A.B.S. function ON/OFF switch can be set with the function select switch func-
tion. (Page 89) PSH or SLD can be selected.
Dial / Trim Setting
The brake return amount (AB.P) and cycle (CYCL) can be controlled with grip dial
GD1, GD2 or digital trim DT3, etc. with the function selection trim function. (Page
88)
Operation Display
When the A.B.S. function is activated, the LED flashes.
Fail Safe Unit
When the 3PJ SUPER is used with the Futaba fail safe unit (FSU-1), it will operate as
described below.
- When the FSU-1 is connected to the throttle channel, and the A.B.S. function has
been activated, the FSU-1 LED will flash each time the servo operates. The reason
for this is that the FSU-1 responds to sudden data changes caused by A.B.S. function
pumping operation. It does not mean that the fail safe function is activated. The servo
will not be affected.
Example of A.B.S. function setting when S9402 used (There will be a
slight difference depending on the state of the linkage.)
- Basic setting
AB.P: Approx. 30% (If this value is too high, the braking distance will increase.)
CYCL: 5~7
DUTY: 0 (When grip is low: - side, when grip is high: + side)
DLY: 10~15%
TG.P: Approx. 70%
STM: OFF
- When the wheels lock, or the car spins, when the brakes are applied fully
AB.P: Increase from 30%
DUTY: Shift from 0 to - side (-1, -2, -3)
DLY: Reduce the delay
- When the braking effect is poor and the braking distance is long when the brakes are
applied fully
AB.P: Decrease from 30%
DUTY: Shift from 0 to + side (+1, +2, +3)
DLY: Increase the delay
54
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
- 3 times