FUTABA 3PJ Super Instruction Manual page 17

Wheel Tension Adjustment
Make this adjustment when you want to change the steering wheel spring tension.
Adjustment
Turn the screw inside the adjusting
hole using a 1.5mm hex wrench.
- Turning the adjusting screw
clockwise, increases the spring
tension.
Caution
If turned too far counterclockwise, the adjusting screw may fall out.
Mechanical ATL Adjustment
Make this adjustment when you want to make the throttle trigger brake (back) side
stroke narrower.
Adjustment
Using a Phillips screwdriver, adjust the trigger
brake (back) side stroke by turning the screw
through the adjusting hole indicated by the ar-
row in the figure. (The screw moves the
throttle trigger stopper.)
- When the adjusting screw is turned clockwise, the
stroke becomes narrower.
Caution
When the stroke was adjusted, the throttle servo travel must be adjusted by data set-
ting.
DIRECT
SELECT
TH.EXP
Tension adjusting
screw
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
Mechanical ATL
adjusting screw
17