Overview Of Options Configurable From A Phone - Cisco 7961G - IP Phone VoIP Administration Manual

Overview of Options Configurable from a Phone

Note
Table 4-1 Settings Configurable from a Cisco Unified IP Phone
Category Description
DHCP settings Dynamic Host Configuration Protocol (DHCP)
automatically assigns IP address to devices when
you connect them to the network. Cisco
Unified IP Phones enable DHCP by default.
IP settings If you do not use DHCP in your network, you can
make IP settings manually.
TFTP settings If you do not use DHCP to direct the phone to a
TFTP server, you must manually assign a TFTP
server. You can also assign an alternative TFTP
server to use instead of the one assigned by
DHCP.
VLAN settings Admin. VLAN ID allows you to change the
administrative VLAN used by the phone. PC
VLAN allows the phone to interoperate with
third-party switches that do not support a voice
VLAN.
Port settings Allow you to set the speed and duplex of the
network and access ports.
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Administration Guide for Cisco Unified CallManager
4-6
There are several options on the Network Configuration menu and on the Device
Configuration Menu that are for display only or that you can configure from
Cisco Unified CallManager. These options are also described in the
Configuration Menu" section on page 4-7
section on page 4-15.
Related Topics
Displaying a Configuration Menu, page 4-2
•
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
or the "Device Configuration Menu"
Network Configuration Menu
Option
DHCP Enabled
DHCP Address Released
Domain Name
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
TFTP Server 1
Alternate TFTP
TFTP Server 2
Admin. VLAN ID
PC VLAN
SW Port Configuration
PC Port Configuration
"Network
OL-11528-01