Safety - Cisco 7961G - IP Phone VoIP Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone

Safety

Warning
Warning
Warning
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Administration Guide for Cisco Unified CallManager
OL-11528-01
If you plan to use auto-registration, verify that it is enabled and properly
configured in Cisco Unified CallManager before connecting any
Cisco Unified IP Phone to the network. For information about enabling and
configuring auto-registration, refer to Cisco Unified CallManager Administration
Guide. Also, see the "Adding Phones to the Cisco Unified CallManager
Database" section on page
You must use Cisco Unified CallManager to configure and assign telephony
features to the Cisco Unified IP Phones. See the
for the Cisco Unified IP Phone" section on page 5-2
In Cisco Unified CallManager, you can add users to the database and associate
them with specific phones. In this way, users gain access to web pages that allow
them to configure items such as call forwarding, speed dialing, and voice
messaging system options. See the
section on page 5-19 for details.
Review the following warnings before installing the Cisco Unified IP Phone. To
see translations of these warnings, refer to the Regulatory Compliance and Safety
Information for the Cisco Unified IP Phone 7900 Series document that
accompanied this device.
Read the installation instructions before you connect the system to its power
source.
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
Ultimate disposal of this product should be handled according to all national
laws and regulations.
2-12.
"Telephony Features Available
"Adding Users to Cisco Unified CallManager"
Before You Begin
for details.
3-3