Cisco 7961G - IP Phone VoIP Administration Manual page 78

Using Cisco Unified IP Phones with Different Protocols
Step 2
Step 3
Converting an In-Use Phone from SCCP to SIP
Converting an In-Use Phone from SIP to SCCP
Step 1
Step 2
Step 3
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Administration Guide for Cisco Unified CallManager
2-18
Chapter 2
If you are not using DHCP in your network, configure the network parameters for
the phone.
See the "Configuring Startup Network Settings" section on page 3-14.
Power cycle the phone.
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
CallManager Administration, choose Bulk Administration > Phones > Migrate
Phones > SCCP to SIP. For detailed information, refer to Cisco Unified
CallManager Bulk Administration Guide.
To convert a phone that is in use in your network from SIP to SCCP, perform these
steps. For more information, Cisco Unified CallManager Administration Guide.
Procedure
In Cisco Unified CallManager Administration, delete the existing SIP phone from
the Cisco Unified CallManager database.
In Cisco Unified CallManager Administration, create the phone as an SCCP
phone.
Power cycle the phone.
Preparing to Install the Cisco Unified IP Phone on Your Network
OL-11528-01