Icom IC-2730E Instruction Manual page 86

13
MAINTENANCE
■ Resetting
Occasionally, erroneous information will be displayed when,
for example, first applying power. This may be caused
externally by static electricity or by other factors.
If this problem occurs, turn OFF power.
After waiting a while, turn ON power again. If the problem is
still there, perform a Partial reset or an All reset.
D Partial Reset
A Partial reset resets the operating settings to their default
values (VFO frequency, VFO settings, MENU contents)
without clearing the items below:
• Memory channel contents
• Call channel contents
1. Push [MENU
• Enters the MENU mode.
2. Rotate [DIAL]S to select "PART" (Partial reset).
( MENU-EXMENU > EXMEN-OTHERS >
OTHER-RESET > RESET-PART)
3. Push [ï]D.
• Displays "RESET?"
4. Rotate [DIAL]S to select "YES."
5. Push [ï]D.
• The transceiver displays "PART RESET," then the partial
reset is completed.
81
• Scan Edge contents
• DTMF memory contents
]C.
D All Reset
BE CAREFUL! An All reset clears all programming and
returns all settings to their factory defaults. See the Full
Manual for details.
1. Push [MENU ]C.
• Enters the MENU mode.
2. Rotate [DIAL]S to select "ALL" (All reset).
( MENU-EXMENU > EXMEN-OTHERS >
OTHER-RESET > RESET-ALL)
3. Push [ï]D.
• Displays "RESET?"
4. Rotate [DIAL]S to select "YES."
5. Push [ï]D.
• The transceiver displays "ALL RESET," then the all reset is
completed.
D isplay
S ide C enter S ide
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
D: Display