Icom IC-2730E Instruction Manual page 47

■ Setting and clearing the skip frequencies
D Setting the skip frequencies
The frequencies set as "PSKIP" channels are not scanned.
1. Start the VFO scan. (p. 41)
• When a signal is received, the scan pauses.
2. To skip the frequency, hold down [MW]C for 1 second
(until 3 beeps sound) while the scan is paused.
• When a signal is received during the scan, the transceiver
attempts to enter the frequency as a skip channel into empty
memory channel 999.
Skip frequency is entered
into channel 999.
• If channel 999 already has content, the transceiver
automatically searches for another blank channel to enter.
If no blank memory channel is found, a beep sounds, and no
skip channel is set.
3. After the skip channel is set, the scan resumes.
The C, S, or D in the instructions indicate the area of the
controller.
C: Center, S: Side, D: Display
D Clearing the skip frequencies
1. Push [MR CALL]S.
• Selects the Memory mode.
2. Rotate [DIAL]
to clear as a skip channel. (Example: 999)
3. Push [MW]C to display the Memory edit screen.
4. Rotate [DIAL]
5. Push [ï]D.
Blinks
6. Rotate [DIAL]
7. Push [ï]D.
8. Rotate [DIAL]
9. Push [ï]D.
10. Rotate [DIAL]
• Displays "OVERW?."
11. Rotate [DIAL]
12. Push [ï]D.
• Beeps sound.
• Clears the skip setting.
For your reference:
The skip setting is also cancelled when the memory
channel set as a skip channel is deleted. (p. 35)
SCAN OPERATION
to select the memory channel you want
S
to select "EDIT."
S
to select "SKIP."
S
to select "OFF."
S
to select "WRITE."
S
to select "YES."
S
5
5
42