Icom IC-2730E Instruction Manual page 13

The following functions can be set to [F-1] and [F-2] to use during receive or in stand-by, or during transmit. (p. 14)
During RX/Standby:
Function Description
--- No function
MONI
Push to open or close the squelch.
([F-2] key: Default)
In the Memory mode, push to select
MR000
Memory channel 000.
In the Memory mode, push to select
MR001
Memory channel 001.
In the VFO mode, push to select an
operating band.
BND.BNK
In the Memory mode, push to select Bank
([F-1] key: Default)
A ~ J, or OFF.
LOnly the programmed bank is displayed.
SCAN Push to start or stop a scan.
Push to set the frequency to be skipped
during scanning.
T-SKIP
The selected frequencies are temporarily
skipped for faster scanning.
MODE Push to change the operating mode.
LOW Push to change the transmit power level.
Push to turn the Duplex mode ON or OFF,
DUP
and the shift direction to DUP+ or DUP–.
PRIO Push to turn the Priority watch ON or OFF.
TONE Push to toggle between tone types.
PANEL DESCRIPTION
Function Description
In the VFO mode, hold down for 1 second
to save the frequency displayed in the
MW
MAIN band into a Memory channel.
L The frequency is automatically saved in a
blank channel.
MUTE Push to turn the Mute function ON or OFF.
Push to display the DTMF code direct entry
DTMFTX
mode screen.
T-CALL Push to transmit a 1750 Hz tone.
During TX:
Function Description
---
No function
([F-2] key: Default)
LOW Push to change the transmit power level.
T-CALL
Push to transmit a 1750 Hz tone.
([F-1] key: Default)
1
1
8