Icom IC-2730E Instruction Manual page 34

4
MEMORY OPERATION
■ Selecting a Memory or Call channel
D Selecting a Memory channel
You can select a Memory channels by rotating [DIAL]S in
the Memory mode.
LIndependently selectable on both the left and right bands.
1. Push [MR CALL]S.
• Selects the Memory mode.
2. Rotate [DIAL]S to select a Memory channel.
• Blank channels are not selected.
Displayed
For your reference: Using the HM-207 microphone (p. 6)
1. Push [VFO/MR
2. Enter the Memory channel number, and then push [ENT].
L When you enter a 3 digit channel number, pushing [ENT] is
not necessary.
D isplay
S ide C enter
29
] to select the Memory mode.
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
S ide
D: Display
D Selecting a Call channel
You can select the Call channels (C0/C1) by rotating
[DIAL]S in the Call channel mode.
Factory default frequencies and operating modes are preset
into the Call channels.
Change these to suit your operating needs.
C0 is for VHF or AIR band, and C1 is for UHF band.
LIndependently selectable on both the left and right bands.
1. Hold down [MR CALL]S for 1 second.
• Selects the Call channel mode.
2. Rotate [DIAL]S to select a Call channel.
Displays the Call channel number
For your reference: Using the HM-207 microphone (p. 6)
1. Hold down [HOME CALL] for 1 second to select the
Call channel mode.
2. Push [▲] or [▼] to select a Call channel.