Icom IC-2730E Instruction Manual page 36

4
MEMORY OPERATION
■ Writing into a Memory or Call channel
D Writing into a blank channel
Example: Writing 434.100 MHz into a blank channel.
1. Push [V/MHz SCAN]S.
• Selects the VFO mode.
2. Set the operating frequency to 434.100 MHz.
• Hold down [MW]C for 1 second.
• Automatically writes into a blank, and returns to the VFO mode.
• Displays "MEMORY FULL" when no blank channel is found.
D Copying Memory content to the VFO
This is convenient when you want to change the frequency
beginning near the Memory or Call channel frequency.
1. Select a desired Memory channel to be copied. (p. 29)
2. Push [MW]C to display the Memory entry screen.
3. Rotate [DIAL]
S
4. Push [ï]D.
• Beeps sound.
• Writes the selected Memory content to the VFO, and returns
to the VFO mode.
31
Displays the
written channel for
about 2 seconds.
to select "TO VFO."
D Copying Memory content to another
Memory channel
You can copy the memory content to another Memory
channel.
1. Select the desired Memory channel to be copied. (p. 29)
2. Push [MW]C to display the Memory entry screen.
3. Rotate [DIAL] to select "COPY."
S
4. Push [ï]D.
5. Rotate [DIAL] to select a target channel.
S
• If you select a pre-entered channel, the previous channel
content is displayed.
6. Push [ï]D.
• Beeps sound.
• Copies to the destination channel.
• When you select a pre-entered channel, "OVERW?" is
displayed. Rotate [DIAL]S to select "YES," and then push
[ï]D to overwrite it.
Select