Table of Contents
Advertisement
Access the subdirectory that corresponds to the driver you wish to
3.
install.
Double click the setup.exe icon corresponding to the driver you
4.
wish to install.
select and install drivers for any hardware that is not currently installed on
the system. Doing so can damage the operating system.
Follow the prompts in the installation wizard to install the driver.
5.
Repeat steps 1 through 5 for each driver you wish to install.
6.
7.
Restart the computer to ensure that the installation process completes
successfully.
Installing Drivers From a Remote CD
If the computer is connected to a network and set up to access a shared
CD-ROM drive, a System Administrator can install the optional drivers
from the NEC Driver CD in the remote CD-ROM drive.
The following procedure applies for both Windows 95 and Windows NT
systems. Differences in the procedure for each operating system are noted
as they occur.
that is not currently installed on the system. Doing so can damage the
operating system.
Install the device that will require the new driver before installing the
1.
driver.
2.
In Windows 95 or Windows 98 systems only, set up the system for
sharing files as follows. On Windows NT systems, go to step 3.
Click Start, scroll up and select Settings, then highlight and
!
select Control Panel from the submenu.
Double click the Control Panel icon on the Windows 95 or
!
Windows 98 desktop.
When you run a setup.exe program, do not
Do not select and install drivers for any hardware
Configuring the System 3-45
Advertisement
Table of Contents
