Table of Contents
Advertisement
Quantum Viking
The Quantum Viking SCSI drive uses jumper blocks A3, A2, A1, and A0
to configure the SCSI ID for the drive. See the documentation that comes
with the drive for more information on when to configure the drive. The
SCSI ID jumpering is listed below.
SCSI ID=0, no jumpers
!
SCSI ID=1, A0 jumpered
!
SCSI ID=2, A1 jumpered
!
SCSI ID=3, A1 and A0 jumpered
!
SCSI ID=4, A2 jumpered
!
SCSI ID=5, A2 and A0 jumpered
!
SCSI ID=6, A2 and A1 jumpered
!
!
SCSI ID=7, A2, A1, and A0 jumpered
SCSI ID=8, A3 jumpered
!
SCSI ID=9, A3 and A0 jumpered
!
SCSI ID=10, A3 and A1 jumpered
!
SCSI ID=11, A3, A1, and A0 jumpered
!
SCSI ID=12, A3 and A2 jumpered
!
SCSI ID=13, A3, A2, and A0 jumpered
!
SCSI ID=14, A3, A2, and A1 jumpered
!
SCSI ID=15, A3, A2, A1, and A0 jumpered
!
NEC 32X CD-ROM Drive
The NEC 32X CD-ROM drive CDR-1900A/PBM uses a three-position
jumper block to configure the master/slave and cable select options. The
user-selectable jumper settings are as follows.
CS: Cable Select jumper - Not used
!
SL: Slave Present jumper
!
— Disabled, pin 2 open (factory default)
— Enabled, pin 2 jumpered
3-54 Configuring the System
Advertisement
Table of Contents
