Changing The Processor Speed - NEC POWERMATE 8100 Manual

configuration.
If your system requires a jumper change, change only the setting for that
condition. Otherwise, keep the jumpers at their factory settings.
The following figure shows jumper locations on the system board.
Locating system board jumper

Changing the Processor Speed

To change the processor speed in the BIOS Setup utility, the system must
be jumpered for Configure mode. In this mode, the system enters the
Maintenance menu when it is restarted.
To change the processor speed, use the following steps.
NECC recommends using needle-nose pliers to move a jumper.
configuration. Only change (or check) the appropriate jumper setting if you
are upgrading the processor. Otherwise, keep the jumpers at their factory
settings.
3-48 Configuring the System
Jumpers are set correctly at the factory for your
Jumpers are set correctly at the factory for your