Table of Contents
Advertisement
2.
Remove the system unit cover (see "System Unit Cover").
If a currently installed hard drive is being replaced:
3.
Label the IDE drive signal and power cables connected to the
!
drive and then disconnect them.
!
Remove the four screws securing the drive to the internal bracket
or the chassis wall.
Remove the drive from the chassis.
!
4.
Insert the new hard drive into the drive slot. Orient the cable
connectors toward the front of the system.
5.
Line up the four holes in the drive with:
the holes in the internal bracket (for the inner slot)
!
the holes in the chassis wall (for the outer of the two slots).
!
6.
Secure the device to the chassis with the four screws that came with
the device or the screws from the old device. The inner drive slot
screws are accessed through the cutouts in the chassis wall (see the
following figures).
Securing a hard drive to the internal bracket
A – Hard Drive
Installing Options 5-61
Advertisement
Table of Contents
