Table of Contents
Advertisement
This completes the Auto Rebuild and Restore procedure.
To reinstall any of the applications or device drivers that came with the
computer, follow the procedures in "Installing Applications."
To install device drivers that did not come with your computer, follow the
procedures in "NEC Driver CD."
Custom Rebuild and Restore
To perform a custom OS Restore with choices on repartitioning and/or
reformatting the hard drive, boot the system from the Select Install CD.
When the system boots from the CD, it automatically loads the MS-DOS-
based Operating System Restore program.
If possible, back up your data before performing an OS restore.
Follow these steps to perform a customized restore of your original,
factory-installed operating system using OS Restore:
Power on or restart the system and immediately insert the Select
1.
Install disc into the CD-ROM drive.
For systems with a SCSI hard drive, a bootable diskette is included
with the NEC Select Install CD. In SCSI systems, first boot the
system from the bootable diskette. After the system boots, proceed
with the NEC Select Install procedure described below.
After the system boots from the CD, the Operating System Restore
Welcome screen appears (see the following figure).
3-32 Configuring the System
Advertisement
Table of Contents
