Table of Contents
Advertisement
Incorrect alignment of the system board
A – Edge of Chassis
B – Latch Open
To prevent damage to the latch, align the system
board with the outside edge of the chassis before closing the latch.
Push the latch closed. This slides the board the rest of the way into
4.
the system unit and secures it into the riser board connector.
If the board does not slide when you push the
latch, slide the board out of the unit a bit and check the alignment position
(see the previous figures). Push the latch closed.
If the system board is aligned correctly, you might need to push the
outside edges of the board to fully seat it into the riser board
connector.
Check the position of the chassis latch. The system board is secured
when the latch is parallel with the outside edge of the board.
C – Edge of System Board
Installing Options 5-31
Advertisement
Table of Contents
