Table of Contents
Advertisement
Move the J5G1 jumper back to pins 1 and 2 so the system can restart
10.
in normal operation mode.
Replace the system unit cover (see "System Unit Cover"). Connect
11.
system power cables and external options.
12.
Power on the system and launch the BIOS Setup utility before POST
and recustomize your BIOS settings.
Clearing a Password
If you forget your password, use the following procedure to clear your
current password and to set a new one. NECC recommends using needle-
nose pliers to move a jumper.
configuration. Only change (or check) the appropriate jumper setting if you
forgot your password. Otherwise, keep the jumpers at their factory
settings.
Access the BIOS Setup utility and record your customized settings. See
"The BIOS Setup Utility."
BIOS settings to their factory defaults.
Before jumpering the system for Configure mode, write down any
customized BIOS settings. When the system is started in Normal mode,
press F2 to bring up the BIOS Setup utility. Recustomize your BIOS
settings.
1.
Power off the system and monitor and unplug any peripherals.
the cover and changing a jumper setting.
Remove the system unit cover (see "System Unit Cover").
2.
3-50 Configuring the System
Jumpers are set correctly at the factory for your
Starting the system in Configure mode resets
The system power must be off before removing
Advertisement
Table of Contents
