Custom Rebuild And Restore - NEC PowerMate Enterprise Manual

8. Remove the CD from the CD tray. Remove the Boot Diskette (if the system being
restored has a SCSI hard disk drive).
9. Click OK to reboot.
This completes the Auto Rebuild and Restore procedure.
To reinstall any of the applications that came with the computer, follow the procedures in
"Restoring Applications."
Restore the application software that didn't come with the computer using the vendor
diskette(s) or CD-ROM(s) included in its original packaging.

Custom Rebuild and Restore

To perform a custom OS Restore with choices on repartitioning and/or reformatting the
hard disk, boot the system from the Select Install CD. When the system boots from the CD,
it automatically loads the MS-DOS-based Operating System Restore program.
Follow these steps to perform a customized restore of the original, factory-installed
operating system using OS Restore:
Power on or restart the system and immediately insert the Select Install disc into
1.
the CD-ROM reader.
The system boots from the CD, and the Operating System Restore Welcome
screen appears (see the following figure).
CAUTION: If possible, back up data before
performing an OS restore.
NOTE: For systems with a SCSI hard disk
drive, a Boot Diskette is included in addition to
the Select Install CD. Boot the system using this
diskette. Then insert the CD.
Setup and Operation 2-41