Omron sysmac NX Series User Manual page 585

File contents (defaults when the file is created)
; --- User Program and Configuration. ---
; Always select "yes".
UserProgram=yes
; --- IP Address of Built-in EtherNet/IP Port Settings. ---
; "yes":will be restored, "no":will not be restored
IPAdr=yes
; --- Present values of variables (Retained variables only). ---
; "yes":will be restored, "no":will not be restored
Variable=yes
:---Unit/Slave Parameters.---
; "yes";will be restored."no";will not be restored
UnitConfig=yes
Note 1. The default file contents when the restore command file is created are given above. All of the data
groups that are listed in the file are set to be restored.
Note 2. The restore command file lists the restorable data groups that were in the backup file when the backup
file was created.
Note 3. Only single-byte alphanumeric characters are used. The text is not case sensitive.
Precautions for Correct Use
When you edit the restore command file, do not change anything in the file except for the "yes"
and "no" specifications for the selectable data groups. If you change anything else in the file,
the Controller may perform unexpected operation when you restore the data.
13-7-4
Specifications of a Controller Verification Results File
This section describes the file name, creation timing, created directory, and verification results confir-
mation method for a Controller verification results file.
File Name
Controller verification results file
File Creation Timing and Created Directories
Function
SD Memory Card
backups
Note However, if the SD Memory Card is write-protected, the verification results files will not be created.
NX-series Safety Control Unit/Communication Control Unit User's Manual (Z395)
13 Backup Functions of the Communication Control Unit
File
Procedure
SD Memory Card Window in
Sysmac Studio
Communication Control Unit
Front-panel DIP Switch
Not used in Communication Control
Unit.
IP address of built-in EtherNet/IP port
yes/no: Restore/Do not restore.
Present values of variables (only vari-
ables that are set to be retained with
the Retain attribute)
yes/no: Restore/Do not restore.
Units and slaves settings
yes/no: Restore/Do not restore.
File name
VerifyResult.log
Creation timing
When verification is Same directory as backup file
executed
When verification is Same directory as backup file
executed
Description
Created directory
13-25
13