Omron sysmac NX Series User Manual page 853

Connection status
General Additional
Status Status
(hex) (hex)
OMRON error code
01 0810
01 0811
15-4-3
CIP Safety Connection Status Codes and Troubleshooting
This section explains how to identify and correct errors based on the connection status of CIP Safety
connection. If the CIP Safety Originator Connection Not Established error or the CIP Safety Target
Missing error occurs with the Safety CPU Unit, the connection status of the CIP Safety connection is
registered to the Attached information.
NX-series Safety Control Unit/Communication Control Unit User's Manual (Z395)
Source of error
Error code returned from target:
New data could not be obtained from the
Communication Control Unit when open-
ing connection. (The Unit will automati-
cally recover, and attempt to open the
connection again.)
Error code generated by originator:
New data could not be obtained from the
Communication Control Unit when open-
ing connection. (The Unit will automati-
cally recover, and attempt to open the
connection again.)
15 Troubleshooting
Handling
Configuration Configuration
1 2
This error may The meaning
occur if the of this error
task period of code is defined
the Communi- by each ven-
cation Control dor, so it de-
Unit was long pends on the
when opening target's specifi-
the connection cations.
or some prob- (Contact the
lem in the Con- target device's
troller caused manufacturer.)
the Controller
to stop.
If the task peri-
od was too
long, operation
recovers auto-
matically. If the
Controller has
stopped, identi-
fy the error
from the error
information in
the Communi-
cation Control
Unit.
This error may The meaning
occur if the of this error
task period of code is defined
the Communi- by each ven-
cation Control dor, so it de-
Unit was long pends on the
when opening target's specifi-
the connection. cations.
If the task peri- (Contact the
od was too target device's
long, operation manufacturer.)
recovers auto-
matically.
Configuration
3
The meaning of
this error code
is defined by
each vendor,
so it depends
on the origina-
tor's specifica-
tions.
(Contact the
originator devi-
ce's manufac-
turer.)
15
The meaning of
this error code
is defined by
each vendor,
so it depends
on the origina-
tor's specifica-
tions.
(Contact the
originator devi-
ce's manufac-
turer.)
15-253