Omron sysmac NX Series User Manual page 44

Regulations and Standards
Conformance to EN ISO 13849-1 and IEC/EN 62061
EN ISO 13849-1 and IEC/EN 62061 require functional safety management to avoid systematic failure
during the software development. This is required in all phases of the life cycle of software program-
ming and software design (e.g., basic software design, safety circuit system design, and software up-
grades) in safety control systems to be developed using safety controllers.
Therefore, functional safety management is required for design and development of software for facili-
ties and equipment that use the function blocks provided in the Safety Controller.
The customer must implement measures to ensure compliance with these standards.
You can download the reliability data for safety of machinery that is required to verify the safety per-
formance of your equipment from the following URL: http://www.ia.omron.com/support/sistemalibrary/
index.html.
Conformance to UL and CSA Standards
The NX-series Safety Control Units comply with the following UL and CSA standards. The application
conditions for standard compliance are defined. Refer to the Instruction Sheet that is provided with
each Unit before application.
Conformance to Shipbuilding Standards
Some NX-series products comply with shipbuilding standards. If you use an NX-series product that
complies with shipbuilding standards and the machinery or system in which you use the NX-series
product must also comply with the standards, consult with your OMRON representative. Application
conditions are defined according to the installation location. Application may not be possible for some
installation locations.
Usage Conditions for NK and LR Shipbuilding Standards
• A Safety Control Unit must be installed within a control panel.
• Gaps in the door to the control panel must be completely filled or covered with gaskets or other ma-
terial.
• The following noise filter must be connected to the power supply line.
Noise Filter
Name Manufacturer
Noise filter Cosel Co., Ltd. TAH-06-683
Conformance to KC Certification
When you use this product in South Korea, observe the following precautions.
42
Model
NX-series Safety Control Unit/Communication Control Unit User's Manual (Z395)