Rear And Front Panels - Roland SonicCell User Manual

USER'S GUIDE

Rear and Front Panels

fig.kakubu-rearPanel.eps
USB COMPUTER Connector
Use a USB cable to connect your computer here.
This connection can handle both MIDI and audio.
• Using the SonicCell with your computer
→ p.31, p.135
USB MEMORY Connector
You can connect USB memory here and
use the SonicCell to play back files (songs)
that have been stored on USB memory.
• Playing back songs → p.28, p.167
Rear Panel
Security Slot
http://www.kensington.com
Front Panel
SAMPLING RATE Switch
This specifies the sampling rate used to record or play back audio data.
After changing this setting, you'll need to turn the SonicCell's power off,
then on again. If you're using software, you'll also need to restart your software.
Be sure to set the [SAMPLING RATE] switch to match the sampling rate setting of
the software you're using.
16
POWER Switch
Turns the power on/off
(p. 18).
MIDI IN/OUT Connectors
You can connect these to other MIDI
equipment to send and receive MIDI
messages.
• Using the SonicCell as a MIDI
sound module → p. 22, p. 54
PHONES Jack
This is a stereo mini-type jack for connecting headphones.
This jack will output the sound received from the INPUT jack
mixed with the sound from the USB-connected computer and
the sound from the SonicCell itself.
Connecting headphones will not mute the sound from the OUTPUT jack.
DC IN Jack
Connect the included AC adaptor
here (p. 18). Do not use any AC
adaptor other than the included
one; doing so may cause
malfunctions.
MASTER VOLUME Dial
This adjusts the volume of the
signals output from the PHONES
jack and OUTPUT jacks (p. 19).