Roland SonicCell User Manual page 208

Effects List
45: SERIAL DELAY
This delay connects two delay units in series. Feedback can be
applied independently to each delay unit, allowing you to
produce complex delay sounds.
fig.MFX-45
L in
Delay 1
Feedback 1
R in
Parameter Range
Delay1 Time 0–1300 ms, note
Delay1
-98– +98%
Feedback #
200–8000 Hz,
Delay1 HF Damp
BYPASS
Delay2 Time 0–1300 ms, note
Delay2
-98– +98%
Feedback #
200–8000 Hz,
Delay2 HF Damp
BYPASS
Pan # L64–63R
Low Gain -15– +15 dB
High Gain -15– +15 dB
Balance #
D100:0W–D0:100W
Level 0–127
208
L out
Pan L
Delay 2
Pan R
Feedback 2
R out
Explanation
Delay time from when sound is
input to delay 1 until the delay
sound is heard
Proportion of the delay sound
that is to be returned to the input
of delay 1 (negative values invert
the phase)
Frequency at which the high-fre-
quency content of the delayed
sound of delay 1 will be cut (BY-
PASS: no cut)
Delay time from when sound is
input to delay 2 until the delay
sound is heard
Proportion of the delay sound
that is to be returned to the input
of delay 2 (negative values invert
the phase)
Frequency at which the high-fre-
quency content of the delayed
sound of delay 2 will be cut (BY-
PASS: no cut)
Panning of the delay sound
Amount of boost/cut for the low-
frequency range
Amount of boost/cut for the high-
frequency range
Volume balance of the original
sound (D) and delay sound (W)
Output volume
46: MOD DELAY (MODULATION DELAY)
Adds modulation to the delayed sound.
When Feedback Mode is NORMAL:
fig.MFX-46a
Balance D
L in
Delay Modulation
Feedback
Feedback
Delay Modulation
R in
Balance D
When Feedback Mode is CROSS:
fig.MFX-46b
Balance D
L in
Delay Modulation
Feedback
Feedback
Delay Modulation
R in
Balance D
Parameter Value
Delay Left
0–1300 ms,
note
Delay Right
Feedback NORMAL,
Mode CROSS
Feedback # -98– +98%
200–8000 Hz,
HF Damp
BYPASS
0.05–10.00 Hz,
Rate #
note
Depth
0–127
Phase 0-180 deg
Low Gain -15– +15 dB
High Gain -15– +15 dB
D100:0W–
Balance #
D0:100W
Level 0–127
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Description
Adjusts the time until the delay sound is
heard.
Selects the way in which delay sound is fed
back into the effect (See the figures above.)
Adjusts the amount of the delay sound
that's fed back into the effect. Negative (-)
settings invert the phase.
Adjusts the frequency above which sound
fed back to the effect is filtered out. If you
don't want to filter out any high frequen-
cies, set this parameter to BYPASS.
Frequency of modulation
Depth of modulation
Spatial spread of the sound
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct sound
(D) and the delay sound (W)
Output level