Tva Settings (Patch Tva/Patch Tva Env Screen); Patch Tva Screen - Roland SonicCell User Manual

Parameter
F-Env Time1–4 ★
(TVF Envelope Time 1–4)
F-Env Level0–4
(TVF Envelope Level 0–4)

TVA settings (Patch TVA/Patch TVA Env screen)

■ Patch TVA screen..........................................................................................................

Parameter
Tone Level ★
Level V-Curve
(TVA Level Velocity Curve)
Level V-Sens
(TVA Level Velocity Sensitivity)
Bias Level
Bias Position
Value Explanation
Specify the TVF envelope times (Time 1–Time 4). Higher settings will length-
en the time until the next cutoff frequency level is reached. (For example,
Time 2 is the time over which Level 1 will change to Level 2.)
0–127
Cutoff
Frequency
★ You can use matrix control to modify this. (p. 95)
Specify the TVF envelope levels (Level 0–Level 4). These settings specify how
0–127 the cutoff frequency will change at each point, relative to the standard cutoff
frequency (the cutoff frequency value specified in the TVF screen).
Value Explanation
Sets the volume of the tone. This setting is useful primarily for adjusting the
volume balance between tones.
0–127
★ You can use matrix control to modify this. (p. 95)
You can select from seven curves that determine how keyboard playing
strength will affect the volume. If you do not want the volume of the tone to
be affected by the force with which you play the key, set this to "FIX."
FIX, 1–7
1
Set this when you want the volume of the tone to change depending on the
force with which you press the keys. Set this to a positive (+) value to have
the changes in tone volume increase the more forcefully the keys are played;
to make the tone play more softly as you play harder, set this to a negative
(-) value.
-63–+63
If you wish to make adjustments to the entire patch while maintaining the
relative values of Level V-Sens among tones, adjust the Velocity Sens (p.
91). However, this setting is shared by the Cutoff V-Sens (p. 103).
Adjusts the angle of the volume change that will occur in the selected Bias
-100–+100 Direction. Larger settings will produce greater change. Negative (-) values
will invert the change direction.
C-1–G9 Specifies the key relative to which the volume will be modified.
Using the SonicCell in Patch Mode
T1 T2 T3
L0
L1 L2 L3
Note on
T: Time L: Level
2 3 4
T4
Time
L4
Note off
5 6 7
105