Using the SonicCell in Patch Mode
Parameter
Dest
(Control Destination)
96
Value
Explanation
Matrix Control Destination selects the tone parameter that is to be controlled when using the Matrix
Control. The following parameters can be controlled. When not controlling parameters with the Ma-
trix Control, set this to "OFF." Up to four parameters can be specified for each Matrix Control, and
controlled simultaneously.
In this manual, Parameters that can be controlled using the Matrix Control are marked with a "★."
If you're not using Matrix Control
●
OFF:
Matrix Control will not be used.
Changing the Pitch
●
PITCH:
Changes the pitch.
Opening and Closing the Filter
●
CUTOFF:
Changes the cutoff frequency.
RESONANCE:
Emphasizes the overtones in the region of the cutoff frequency, adding
character to the sound.
Changing the Volume and Pan
●
LEVEL:
Changes the volume level.
PAN:
Changes the pan.
Changing How the Effects Are Applied
●
OUTPUT LEVEL:
Changes the volume of output levels.
CHORUS SEND:
Changes the amount of chorus.
REVERB SEND:
Changes the amount of reverb.
Applying LFO to Modulate Sounds
●
LFO1/LFO2 PCH DEPTH:
LFO1/LFO2 TVF DEPTH:
LFO1/LFO2 TVA DEPTH:
LFO1/LFO2 PAN DEPTH:
LFO1/LFO2 RATE:
Changing the Pitch Envelope
●
PIT ENV A-TIME:
Changes the Env Time 1 of the pitch envelope.
PIT ENV D-TIME:
Changes the Env Time 2 and Env Time 3 of the pitch envelope.
PIT ENV R-TIME:
Changes the Env Time 4 of the pitch envelope.
Changing the TVF Envelope
●
TVF ENV A-TIME:
Changes the Env Time 1 of the TVF envelope.
TVF ENV D-TIME:
Changes the Env Time 2 and Env Time 3 of the TVF envelope.
TVF ENV R-TIME:
Changes the Env Time 4 of the TVF envelope.
Changing the TVF Envelope
●
TVA ENV A-TIME:
Changes the Env Time 1 of the TVA envelope.
TVA ENV D-TIME:
Changes the Env Time 2 and Env Time 3 of the TVA envelope.
TVA ENV R-TIME:
Changes the Env Time 4 of the TVA envelope.
Splitting Tones That Are Played
●
TMT
If the Matrix Control is used to split tones, set the TMT Velo Ctrl (p. 112) to "OFF," and the TMT Ctrl
Switch (p. 112) to "ON."
• If the Matrix Control is used to split tones, we recommend setting the Sens (p. 97) to "+63."
Selecting a lower value may prevent switching of the tones. Furthermore, if you want to reverse
the effect, set the value to "-63."
• If you want to use matrix control to switch smoothly between tones, use the Velo Fade Lower and
Velo Fade Upper (p. 113). The higher the values set, the smoother the switch is between the
tones.
Changes the vibrato depth.
Changes the wah depth.
Changes the tremolo depth.
Changes the effect that the LFO will have on pan.
Changes the LFO cycle rate. Changes the speed of the LFO cycles.
The speed will not change if LFO Rate is set to "note."